ESD protection enhancement how-to

Revision as of 16:44, 24 August 2011 by Dragan (talk | contribs)

Introduction

This how-to will guide you step by step to mount the Barix ESD protection enhancement springs.

The springs can be ordered directly with Barix using this form: "Link coming soon"

To enlarge click on any of the photos.


Step 1: Preparation

Unpack the device and the springs. Place the device on the table with the rear plate facing up.

Error creating thumbnail: File missing
Error creating thumbnail: File missing


Step 2: Unscrewing the bolts

Use appropriate tools to unscrew the left and right Dsub bolts of the RS-232 connector. Place the bolts aside for mounting in the final steps.

Error creating thumbnail: File missing
Error creating thumbnail: File missing


Step 3: Placing the springs

Use pliers or a tweezer to place the springs in the slot between the RS-232 connector and the enclosure.

  • The bent part with the screw hole must be placed facing up!
  • Place the spring to fit the screw hole for easy mounting of the bolts.
  • Production tolerances might prevent you from placing both spring which is ok as long as one spring is touching the enclosure.
Error creating thumbnail: File missing
Error creating thumbnail: File missing
Error creating thumbnail: File missing


Step 4: Screwing back on the bolts

Use appropriate tools to screw back on the left and right Dsub bolts of the RS-232 connector.

  • Place both bolts in losely before tightening them!
  • Tighten both bolts to prevent accidental untightening.
Error creating thumbnail: File missing
Error creating thumbnail: File missing
Error creating thumbnail: File missing