RTP Buffering - Frame Based Buffering

Introduction

In Song module version 8 a new RTP buffering method called frame based buffering was introduced. The algorithm calculates the audio buffer level in milliseconds rather than in bytes.

Features

Frame based buffering allows:

  • configurable decoding delay with one frame accuracy
  • synchronisation of several decoders to the same stream (just by configuring them to the same initial delay)
  • stable delay over long period of time
  • automatic correction of clock difference between encoder and decoder

Applications

The following applications use frame based buffering:

Application Name Version
Streaming Client 2.17
Annuncicom Full Duplex 0.21
RTP STL 2.01

Configuration

The only configuration parameter for the RTP decoder is the delay in milliseconds.

The delay parameter is the desired processing delay of the decoder (between the network input and the audio output). Please note that the end-to-end delay between the encoder and the decoder might be (significantly) different to the value configured.

In an ideal case the delay parameter would be 0 ms, however due to device's internal buffers a small delay (depending on the hardware) is inevitable. The delay value should also cover possible temporary network hick-ups. E.g. if the network might sometimes delay the packet delivery by 20ms due to a temporary load, the configured parameter should not be less than 20ms.

The maximum configurable delay is limited by the device's internal buffer (64, 32 or 16kB).

The following sections show recommended delay values for various audio formats.

Recommended Settings

Detailed Settings

MP3

PCM

Multiple Device Synchronisation

Multiple devices receiving the same RTP stream can be configured to play in sync by entering the same delay parameter.

Barix recommends to use broadcast or multicast together with synchronisation, otherwise a small inaccuracy (few milliseconds) might be caused by the network delivery to different locations.

Deliberate Delays

In some applications it is desired to artificially delay the audio. E.g. in a tunnel to eliminate the delay caused by the distance between the devices.

An artificial delay can be introduced by configuring the devices to different delay values. E.g. 100ms, 120ms, 140ms, 160ms, etc.