Configuration Update

Configuration Location

The current configuration is stored in a non-volatile memory (EEPROM). The memory layout depends on the specific Firmware. If you updated the device with a new Firmware make sure to apply the “factory defaults configuration”. The current configuration can be changed via the web user interface. When hit the “Apply” button the new values are stored into the EEPROM.

Factory defaults using Serial Rescue

The EEPROM is overwritten during a Serial Rescue by the factory defaults configuration using the binary file config.bin which is located in the folder “update_rescue” of the delivered Firmware Update Kit. This file can be edited with a hex editor. Consult the “configuration memory usage” table carefully before you make any changes.

Factory defaults using Web Update

The “factory defaults configuration” (config.bin) is also contained in the application image which is loaded into the flash memory. When applying the “Web Update” make sure to apply the “factory defaults configuration” by pushing the reset button for more than 10 seconds.