Difference between revisions of "Asterix Server configuration for Relay control"

 
(One intermediate revision by one other user not shown)
Line 1: Line 1:
==Example configuration of Asterix Server for controlling Relays on Annuncicom SIP Client==
==Example configuration of Asterisk Server for controlling Relays on Annuncicom SIP Client==


Here is the actual configuration as a showcase of our company Asterisk server. We use two different extensions, reachable from even outside, which connect to an Annuncicom 1000 and select/deselect the relays at connnection establishment.  
Here is the actual configuration as a showcase of our company Asterisk server. We use two different extensions, reachable from even outside, which connect to an Annuncicom 1000 and select/deselect the relays at connnection establishment.  
Line 13: Line 13:
AND, sure, you can hide the relay selection from the user also by setting up dial-able extensions within Asterisk which use the same target and just do the relay selection. There is no difference between internal and external extensions in that sense in Asterisk.  
AND, sure, you can hide the relay selection from the user also by setting up dial-able extensions within Asterisk which use the same target and just do the relay selection. There is no difference between internal and external extensions in that sense in Asterisk.  
Other SIP based systems work similar.
Other SIP based systems work similar.
Back to [[Main_Page#Software_Topics]]

Latest revision as of 13:30, 10 April 2013

Example configuration of Asterisk Server for controlling Relays on Annuncicom SIP Client

Here is the actual configuration as a showcase of our company Asterisk server. We use two different extensions, reachable from even outside, which connect to an Annuncicom 1000 and select/deselect the relays at connnection establishment. The commands sent (via SIP INFO/RFC2833) are just examples, the complete set is documented with the SIP Client firmware.

In the example below, extension 9999 is an Annuncicom 1000, and by dialling +4143xxxxxxx from external phone line, you will be connected to the Annuncicom and all relays will be reset (off - value 0), in the second line, if you dial +4143xxxxxxy, right after connection initiation, relays 1+2 (bit 0 and 1, value 3 in decimal) will be set to on.

exten => 043xxxxxxx,1,Dial(SIP/9999,10,D(#2*0*))        ;  can be reached from external 
exten => 043xxxxxxy,1,Dial(SIP/9999,10,D(#2*3*))        ;  can be reached from external 

Of course, you can also send such commands (#2*7* for example to set relay 1,2,3) while the connection is established from the calling phone, if it supports DTMF and all handling of the incoming phone is set up correctly in Asterisk (that is beyond our scope, standard Asterisk docs explain that well).

AND, sure, you can hide the relay selection from the user also by setting up dial-able extensions within Asterisk which use the same target and just do the relay selection. There is no difference between internal and external extensions in that sense in Asterisk. Other SIP based systems work similar.

Back to Main_Page#Software_Topics