Default Configuration Customization

How to customize the default configuration settings of your Barix Audio product.

WARNING: The following tips are intended only for expert users of Barix products as they may cause misconfiguration of the devices.

Standard Firmware Package

The configuration information are contained in one file

► config.bin located in folder "webuidevkit/xxxxapp" where xxxx depends on the SW package.

The same file is copied also in folder "update_rescue".

In order to create a custom version of the Default Configuration you need to do the following:

change with binary-editor the configuration values in the config.bin file
run the web2cob command (batch file available in the package) to generate the file xxxxapp.cob
copy the config.bin and the xxxxapp.cob file in the update-rescue folder
run the load_win command (batch file gen.bat available in the package) to generate the compound.bin file

NOTE: the configuration parameters mapping can be found in the Technical Documention of the Firmware

The configuration information are contained in two different files

► config.bin located in folder "webuidevkit/abclapp" for the common abcl settings

► appconfig.bin located in folder "bcldevkit" for the application specific settings

These 2 files are merged in a new config.bin file in folder "update_rescue".

In order to create a custom version of the Default Configuration you need to do the following:

change with binary-editor the configuration values in the config.bin file (1)
run the web2cob command (batch file abclapp.bat available in the package) to generate the file abclapp.cob
change with binary-editor the configuration values in the appconfig.bin file (2)
run the tokenizer and web2cob commands (batch file applctns.bat available in the package) to generate the file applications.cob
merge the two configuration files into one (e.g. use "cat" from command-line: cat config.bin appconfig.bin > config.bin)
copy the config.bin, abclapp.cob and the applications.cob file in the update-rescue folder
run the load_win command (batch file gen.bat available in the package) to generate the compound.bin file

NOTE (1): the configuration parameters mapping can be found in the Technical Documention of the Firmware

NOTE (2): the configuration parameters mapping can be found in the EEPROM layout Documention in the same folder

IMPORTANT: Do not forget to apply "Factory Defaults" after uploading the new binaries on the device.