Difference between revisions of "How To trigger Relays using metadata"
| Line 1: | Line 1: | ||
==TRIGGER A RELAY ON STREAMING CLIENT USING METADATA== | ===TRIGGER A RELAY ON STREAMING CLIENT USING METADATA=== | ||
==Exstreamer Configuration== | |||
- STREAMING CLIENT firmware. | |||
- STREAMING SETTINGS → 1. URL: http://<ip-instreamer>:<port>/xstream (You can change “xstream”). | |||
- I/O SETTINGS → Control Output 1: Remote. | |||
==From Instreamer== | |||
To send metadata to the Instreamer for inclusion with the stream, please use the E= command. | To send metadata to the Instreamer for inclusion with the stream, please use the E= command. | ||
| Line 24: | Line 33: | ||
- STREAMING SETTINGS → STREAMING DESTINATIONS use “Internet Radio”. | - STREAMING SETTINGS → STREAMING DESTINATIONS use “Internet Radio”. | ||
== | ==From Icecast/Shoutcast server== | ||
Revision as of 07:10, 26 May 2015
TRIGGER A RELAY ON STREAMING CLIENT USING METADATA
Exstreamer Configuration
- STREAMING CLIENT firmware.
- STREAMING SETTINGS → 1. URL: http://<ip-instreamer>:<port>/xstream (You can change “xstream”).
- I/O SETTINGS → Control Output 1: Remote.
From Instreamer
To send metadata to the Instreamer for inclusion with the stream, please use the E= command.
In order to trigger the Relays on the device running the Streaming Client FW you have to issue the following command on the source
"E=StreamUrl='X'”
where 'X' is the bit mask for the Relay with offset 'A' i.e. 'A' to turn off all Relays, ‘B‘ to activate Relay 1 ...
http://<ip-instreamer>/rc.cgi?E=StreamUrl='A'; http://<ip-instreamer>/rc.cgi?E=StreamUrl='B';
Instreamer Configuration
- INSTREAMER firmware.
- STREAMING SETTINGS → SHOUTCAST/ICECAST SETTINGS → Radio Path → “/xstream”. (You can change “xstream”).
- STREAMING SETTINGS → STREAMING DESTINATIONS use “Internet Radio”.
