Difference between revisions of "How To trigger Relays using metadata"
(New page: ==TRIGGER A RELAY ON STREAMING CLIENT USING METADATA== To send metadata to the Instreamer for inclusion with the stream, please use the E= command. In order to trigger the Relays on the ...) |
|||
| Line 2: | Line 2: | ||
To send metadata to the Instreamer for inclusion with the stream, please use the E= command. | To send metadata to the Instreamer for inclusion with the stream, please use the E= command. | ||
In order to trigger the Relays on the device running the Streaming Client FW you have to issue the following command on the source | In order to trigger the Relays on the device running the Streaming Client FW you have to issue the following command on the source | ||
| Line 8: | Line 9: | ||
where 'X' is the bit mask for the Relay with offset 'A' | where 'X' is the bit mask for the Relay with offset 'A' | ||
i.e. 'A' to turn off all Relays, ‘B‘ to activate Relay 1 ... | i.e. 'A' to turn off all Relays, ‘B‘ to activate Relay 1 ... | ||
http://<ip-instreamer>/rc.cgi?E=StreamUrl='A'; | http://<ip-instreamer>/rc.cgi?E=StreamUrl='A'; | ||
Revision as of 14:28, 24 October 2014
TRIGGER A RELAY ON STREAMING CLIENT USING METADATA
To send metadata to the Instreamer for inclusion with the stream, please use the E= command.
In order to trigger the Relays on the device running the Streaming Client FW you have to issue the following command on the source
"E=StreamUrl='X'”
where 'X' is the bit mask for the Relay with offset 'A' i.e. 'A' to turn off all Relays, ‘B‘ to activate Relay 1 ...
http://<ip-instreamer>/rc.cgi?E=StreamUrl='A'; http://<ip-instreamer>/rc.cgi?E=StreamUrl='B';
Instreamer Configuration
- INSTREAMER firmware.
- STREAMING SETTINGS → SHOUTCAST/ICECAST SETTINGS → Radio Path → “/xstream”. (You can change “xstream”).
- STREAMING SETTINGS → STREAMING DESTINATIONS use “Internet Radio”.
Exstreamer 110 Configuration
- STREAMING CLIENT firmware.
- STREAMING SETTINGS → 1. URL: http://<ip-instreamer>:<port>/xstream (You can change “xstream”).
- I/O SETTINGS → Control Output 1: Remote.
