Difference between revisions of "BCL programming tips"
| (2 intermediate revisions by one other user not shown) | |||
| Line 1: | Line 1: | ||
== Network Address == | |||
* ''Can I get the device's current IP in my BCL program?'' | |||
Yes, to do so use '''SPRINTF$''' with the '''%A''' format string: | |||
<pre> | |||
ip$=SPRINTF$("%A",1) | |||
</pre> | |||
The '''ip$''' will contain e.g.: | |||
192.168.2.100 | |||
To obtain the IP address with leading zeroes use: | |||
ip$=SPRINTF$("%1A",1) | |||
The '''ip$''' will then contain e.g.: | |||
192.168.002.100 | |||
See more in the chapter Formatted String Conversions - SPRINTF of the BCL Programmers Manual. | |||
== RTP decoding == | == RTP decoding == | ||
* using LINK | * using LINK | ||
| Line 46: | Line 68: | ||
== UDP source/destination ports == | == UDP source/destination ports == | ||
* source port is the same as the port in the open statement | * source port is the same as the port in the open statement | ||
== How to get more variables == | |||
The current BCL interpreter supports only up to 96 integer and string variables. In complex programs this can be a significant limitation. | |||
You can increase the actual number of integer variables in the program by using integer arrays. | |||
Back to [[Main_Page#Software_Topics]] | |||
Latest revision as of 13:11, 10 April 2013
Network Address
- Can I get the device's current IP in my BCL program?
Yes, to do so use SPRINTF$ with the %A format string:
ip$=SPRINTF$("%A",1)
The ip$ will contain e.g.:
192.168.2.100
To obtain the IP address with leading zeroes use:
ip$=SPRINTF$("%1A",1)
The ip$ will then contain e.g.:
192.168.002.100
See more in the chapter Formatted String Conversions - SPRINTF of the BCL Programmers Manual.
RTP decoding
- using LINK
RTP streaming
- MP3 bit reservoir
Audio handling
- reading/writing must happen in "real time"
Tips for writing efficient programs
- use ON var GOTO
- do not use large if then or nested if then
UDP reception
- lastlen trick
- must proceed all UDP packets in the handler
Multicast
BCL supports up to 16 IP multicast groups at a time. The subscription, periodic membership reporting as well as group leaving is performed automatically by the firmware and does not have to be handled by the BCL application. IGMP version 1 and 2 is supported.
Subscribing to a group
To subscribe to a multicast group enter the desired multicast address to the UDP open statement.
Example:
OPEN "UDP:224.10.1.3:5000" as 1
Leaving the group
The group is automatically left if the respective handle is closed:
CLOSE 1
UDP source/destination ports
- source port is the same as the port in the open statement
How to get more variables
The current BCL interpreter supports only up to 96 integer and string variables. In complex programs this can be a significant limitation. You can increase the actual number of integer variables in the program by using integer arrays.
Back to Main_Page#Software_Topics
