Green and Red LED

Application is starting:

• • First the red goes on and the green LED blinks once.
  • Then during the startup the green and red LEDs are blinking. During DHCP the red LED is blinking always and the green LED is blinking alternate for five times and then pause for four times. After SonicIP the red will go off.
  • If the application is corrupt the red led is on and the green LED blinks five times. After that the device resets itself.
  • If the network hardware could not be initialized the red led is on and the green LED blinks three times. After that the device resets itself.
  • If the MAC address is corrupted the red led is on and the green LED blinks three times. After that the device resets itself.
  • If an IP address conflict occurs the red led is on and the green LED blinks five times. After that the device resets itself.
  • If on zServer is found the green LED blinks very slowly.

Application is running:

• • The red LED always is off.
  • On stop/pause the green LED is on.
  • During playing the green LED is blinking slowly.
  • On playing the gong or idle application the green LED is blinking fast with breaks.
  • As sync slave the green LED blinks slow with green LED is blinking fast with breaks.
  • On streaming receive the green LED blinks fast.

Serial Configuration is activated: The red LED is blinking always. The green LED is on for four times blinking of the red LED and then off for four red LED blinks.

Telnet Configuration is activated: The red LED is blinking always. The green LED is blinking four times with the red LED and then pause for four red LED blinks.

No Application loaded (only bootloader) or started with hold reset button during power up: The green LED is on and the red LED is blinking.

Device after production with bootloader but without MAC: The green and the red LED are blinking alternate. Indicates waiting for the factory test. During the factory test the blinking remains. If the test has been successful the red LED stops blinking. If the test fails the green LED stops blinking.

Back to FAQ